MTRemote — Installation guide

MTRemote — Installation guide

5 September 2026, 13:03
Rustamzhan Salidzhanov
0
147

MTRemote — MTAgent installation guide



📋 REQUIREMENTS

  • Windows [10 / 11] on the computer or VPS where your terminals run
  • MetaTrader 4 and/or MetaTrader 5 with the MTRemote Expert Advisor
  • A regular internet connection — no inbound ports, no router setup, no administrator rights required

─────────────────────────────────────────────

⚙️ INSTALLATION

  1️⃣  Install MTAgent
      Download the installer using the link above and run it on the computer where your terminals are running.
      MTAgent is installed once per computer and serves all terminals on it.

  2️⃣  Set your password
      On first launch, set a password in MTAgent. The encryption key is derived from this password and never leaves your computer.
      Remember it — without it the panel cannot decrypt your data.

  3️⃣  Attach the Expert Advisor
      Attach the MTRemote Expert Advisor to one chart in every terminal that should appear in the panel. One chart per terminal is enough.
      The Expert Advisor shows the connection status with MTAgent, the last sync time and the product version.
      To manage trading and Expert Advisors from the panel, enable Algo Trading in the terminal.

  4️⃣  Connect the panel
      Open the web panel: [PANEL LINK]
      Scan the QR code shown in MTAgent or enter the PIN — your terminals will appear in the panel.

─────────────────────────────────────────────

🔄 UPDATING

Whenever the MTRemote Expert Advisor is updated, download and install the latest version of MTAgent from the link above.
The Expert Advisor and MTAgent versions must match — otherwise the connection will not be established.

─────────────────────────────────────────────

🛠️ TROUBLESHOOTING

  • The Expert Advisor shows no connection — make sure MTAgent is running on the same computer and that its version matches the Expert Advisor version.
  • A terminal does not appear in the panel — check that the Expert Advisor is attached to a chart in that terminal and shows a successful connection.
  • Trading commands from the panel are not executed — enable Algo Trading in the terminal and in the Expert Advisor properties.
  • The panel cannot connect to the agent — check the internet connection on the computer with MTAgent and re-enter the PIN or scan the QR code again.

─────────────────────────────────────────────

🔒 SECURITY

  • End-to-end encryption between MTAgent and the panel — no intermediate server can decrypt the data.
  • The Expert Advisor loads no external libraries, makes no web requests and talks only to the local MTAgent over a pipe.

─────────────────────────────────────────────

💬 SUPPORT

Questions, bug reports and feature requests — in the "Discussion" and "Comments" tabs on the product page:
  • MTRemote for MT5
  • MTRemote for MT4