Nice

This strategy is typically a breakout trader and is more active in volatile markets.

1. USDCHF
2. GBPUSD
3. USDCAD
   
4. Others...

Settings

• Comment
• The Trade Comment.
• Magic
  1 = Magical Trading
• Market Slippage
  The slippage in each order request.
• Tick Filter
  A value of 2 means the pending orders are only adjusted every 2nd tick, higher values enable higher trading frequency and lower values allow better quality trading.
  Values: 1 - 5
• Tick Samples
  The number of ticks used to calculate the average spread value.
  Values: 30 - 300
• Trade Request Seconds
  The minimum number of seconds between each trade request. Some brokers only allow 1 request per second.
  Values: 1 - 60
• Order Modify Seconds
  The number of seconds to adjust the pending stop orders.
  Values: 60 - 900
• Start Hour
  The start hour for trading each day.
  Values: 0 - 23
• End Hour 
  The end hour for trading each day.
  Values: 0 - 23
• Aggressive
  The factor at which aggressive trading is activated. 
  A value of 1 is least aggressive and does not allow additional trades to be opened.
  Values: 1 - 5
  
  If you trade with a value greater than 1.0 then its recommended that you have a Secondary Terminal.
• Max Spread Limit
  The maximum spread in points used to open new trades.
• Min Spread Limit
  The minimum spread in points used to calculate trade parameters.
  This is an important parameter for pairs that have low spread it allows the strategy to trade similar to larger spreads.
  
  The following settings are all measured as a representation of the pair's spread.
• Signal Size
  The distance measured in spreads that the strategy uses as it's signal to open positions or adjust orders.
  Values: 0.5 - 5.0
• Order Distance 
  The distance measured in spreads that the order will be placed from the market price.
  Values: 1.0 - 100.0
  
• Max Distance
  The maximum distance to keep orders within this distance in spreads from the price.
  This value must be greater than Order Distance.
• Stop Loss
  The number of spreads used for the Stop Loss.
  Values: 1.0 - 100.0
• Max Trailing
  The maximum distance the trailing stop will be set.
  Values: 1.0 - 100.0
• Trailing Target
  The distance used to calculate the lag on the trailing stop.
  Values: 1.0 - 50.0 
  
  This value should be greater than the Max Trailing value.