I've tested several of your RSI mtf alert indicators and like the one attached. There's one small function I can't quite get, but perhaps don't understand the settings correctly. I have email alerts set but it often sends message that it has crossed the alert line going down or up but as I measure by the Data tools it isn't above/below that level. I have Fasle for 'Use Current bar' thinking that will stop it from reporting until the bar is closed. This would avoid the noise of market fluctuations.
Example I'd like to have the alert go off when the RSI moving up, closes at a bar time of my choosing, greater than 53. Then a down alert signaled when the RSI closes below 47. The 47/53 is to avoid the noise near the 50 level. The settings as I describe would allow me to run it on a 4H chart but have the alert report on bar closes on the 1H chart, 30m, or the 4H, etc..
In the attached indicator I noticed that arrows are included in the code but not in the settings window. Could on chart arrows be an option?
Lower time frames can not be seen (or alerted for) on the higher time frames. There is simply no way how to decide which is the most significant bar of the lower time frame and why the rest should b ignored
OK. The other issue was about alerts occurring on the open bar. Example: on the 4H time chart, with setting to "Current time frame", 'Alerts on Zone Exit", and "Alerts on Current" to False. the RSI crossing alert is signaled during the four hours whenever the RSI reading crosses the alert level. Is there a current combination of settings, or could add the option, so that an alert is only signaled at close of the time bar, based on RSI at the time?
Thank you so much Mladen for RSI zones indicator
Have a nice weekend
Rsx in color indicator : rsx_in_color.mq4
One more version of rsi chart bars
Sylvain Vervoort's Asymertical RSI
RSI TC new indicator rsi-tc_new.mq4