Multi Timeframe Indicators - page 789

jemchug
25
jemchug  
mladen:
jemchug

Please read this post : https://www.mql5.com/en/forum/173574/page523

regards

Mladen, thanks.

It is really bad indicator. I looked at time of emergence of an arrow for M15 and transferred to M1. The arrow on M1 really would appear only after 15 bars (if to put M15). And it is loss of pips. It is a pity. Thanks, correctly I was directed.

Jemchug - Natasha.

talaate
967
talaate  

Dear Mladen......I would appreciate if you may make ADX candle indicator in MTF....Thanks in advance...Talaat E.......

Files:
rocktheedge
69
rocktheedge  

mladen i dont know its compile or not .. there is no parameter to change in this indicator .. like others i sent to you .. can you please check out and add parameters to change thanks

Files:
William Snyder
9492
William Snyder  
Rocktheedge:
mladen i dont know its compile or not .. there is no parameter to change in this indicator .. like others i sent to you .. can you please check out and add parameters to change thanks

Rocktheedge, its decompiled but I think it's this indicator, and there are parameters to change.

Files:
Aya Mousa
52
Aya Mousa  

Thanks Mladen.

What I've discovered that these two indicators attached by me are not MTF indicators!

They does not repaint higher TFs when applied to smaller TFs, as all the MTF indicators do.

They show the ichimoku cloud position on any time frame, with no repainting.

Please refer me to such indicator if it was previously posted here on forex-tsd, or I don't know If you or Mrtools can write this indicator for the forum so we can all benefit from it

Thanks in advance ..

P.S: The two attached indicators has the same results.

hyrulxxx
29
hyrulxxx  

HI needs somebody helps to change the indicator to be an arrow like below

Mladen Rakic
154063
Mladen Rakic  
hyrulxxx:
HI needs somebody helps to change the indicator to be an arrow like below

hyrulxxx

Find the lines that are going like this :

SetIndexArrow(0, 119);

SetIndexArrow(1, 119);

and change 119 to a number besides the desired character from this table :

Files:
chars.gif 37 kb
talaate
967
talaate  

dear Mladen..........dear Mrtool..........please kindly look to this post #7889 https://www.mql5.com/en/forum/173574/page526

Martin
36
Martin  

Dear Mladen,

could it be possible to make MACD 2x mtf nmc with RSI adaptive?

page 641

Thanks in advance

Mladen Rakic
154063
Mladen Rakic  
makoz:
Dear Mladen,

could it be possible to make MACD 2x mtf nmc with RSI adaptive?

page 641

Thanks in advance

Sorry, but I do not quite understand what is the idea. Would you mind clarifying it?