Nt8 indicator change

attached is an nt8 indicator i would like modifications to. this will not be simple. once you review the indicator you will see it prints arrows and dots. the arrows print after the dots stop forming. 

i am using default settings, on the instrument es, using ninza renko 8:4

i want the arrow to be placed on the first dot. 

i do not want the arrow to just be backpainted into the past much like a swing indicator or zigzag. the arrow must print in real time on the first dot and match the originial arrow direction 1:1

so if theres 30 up arrows and 60 down arrows on the originial then your indicator must match it, only diffrerence is the arrow placement. thats the only difference

this is where i need a good coder or developer. because the signaling used to create the original arrow only happens after the dots stop printing. so there needs to be a good signaling identifier to predict the original lagging arrow

so the goal is to place the arrow on the first dot and have it print on the first dot in real time and have it match the same arrow direction to the original arrow. when a dot prints its either a reveral or continuation. i do not know how to figure out how to perdict it perfectly or even within 90% 

attached is the indicator and a screenshot of my explanation of what i want. the white arrows are the original and the blue arrows show here i want the arrow in real time on that first dots candle close. youll see 1:1 matching