Debug existing code to take trades based on existing logic

I need someone to apply a quick fix to it so that it takes trades according to this logic:

Requirement for Entering Trades with 2 Exponential Moving Averages (EMA):

1. Setup:

   • Utilize two Exponential Moving Averages (EMA): a fast moving average (FMA) and a slow moving average (SMA).

2. Entry Conditions:

   • Scenario 1: If the slow moving average (SMA) is above the fast moving average (FMA):

     • When three consecutive candles close above the fast moving average (FMA), enter a pending trade.
     • Set the pending trade entry point 'x' points above the high of the third closed candle.

   • Scenario 2: If the slow moving average (SMA) is below the fast moving average (FMA):

     • When three consecutive candles close above the fast moving average (FMA), enter a pending trade.
     • Set the pending trade entry point 'x' points above the high of the third closed candle.

3. Stop Loss (SL):

   • If the slow moving average (SMA) is above the fast moving average (FMA):
     • Place the stop loss 'x' points below the fast moving average (SMA).
   • If the slow moving average (SMA) is below the fast moving average (FMA):
     • Place the stop loss 'x' points below the slow moving average (SMA).

4. Take Profit (TP):

   • If the slow moving average (SMA) is above the fast moving average (FMA):
     • Set the take profit 'x' points below the slow moving average (SMA).
   • If the slow moving average (SMA) is below the fast moving average (FMA):
     • Omit setting a take profit.

5. Trade Management if Take Profit (TP) is Hit:

   • If the take profit is reached:
     • If the take profit is below the slow moving average (SMA):
       • Place a pending order if three candles close above the slow moving average (SMA).
       • Set the pending order entry 'x' points above the high of the third closed candle.
       • Place the stop loss 'x' points below the slow moving average (SMA).
       • Omit setting a take profit for this pending order