Bar Indicator to send order and close order

Requirements:

1.      Send buy order when N continuous bar is UP (N in input variable)

2.      Send Sell Order when N continuous bar is DOWN (N is input variable)

3.      Above check will only happen when bar change to new BAR . ie if Time frame is H1 (in input variable)  and  N =5 then code need to check “H1[2],H1[1] AND if both bar are going up then buy order same if both bar is down then SELL ORDER

4.      While sending order take 1% of lot size of total balance always put stop loss and take profit . apply take profit very minimal 5$ on .01 lot size -OPTION 1 SET USING FLAG

5.      Further to check if order need to close in between: check below condition and close the order.

a.      If first 5 Bar (H1)is UP then apply Buy order but once 3(Dynamic) continuous (H1 Or 30M dynamic timeframe global variable) order is down then close the order.

b.      Same wat if first 5 ber is down then apply sell order but once 3 (Dynamic) continuous (H1 Or 30M dynamic timeframe global variable) order is up then close the order.

need input variable to choose dynamic time stamp for send order.

input variable for number of bar to check continuous bar up or down

need input variable to choose dynamic time stamp for check close order.

input variables for number of bar check continuous bar up or down to close order

function to check if bar is complete bar ( this should be called based on flag so if needed then apply else don’t apply