The expert advisor works very well, thank you!

But I have a problem when copying instruments with different names.

EURUSD=EURUSDp     .... this works

US500=SPX500          ..... this works

But XTIUSD=WTI       ...... this does not work

Please can you help?

Hello,

Global Prime has XTIUSD

BlackBull Markets has WTI

Thank you

I'm sorry to bother you again.

I just figured it out.

The ratio needs to be changed on the receiver account

hello again,

in section 2.2 of the expert advisor, when are you going to implement the second option of copying Each POSITION?

Is this something you will implement in a paid version of the Expert advisor?

That's good

Initially, I planned to implement both copy modes in one Expert Advisor. But now, after the start of the implementation of the Each POSITION mode, it became clear that these modes are too different and their implementation in one Expert Advisor will make it difficult to use, maintain and develop.
Therefore, now I plan to implement the second copy mode in a separate product. Its publication time is about a month later. For a while, it will be available on the market for free. Then only the version will remain available for free, where copying will be processing from any account to a demo account.

Thank you for the update!

I would even pay for this feature without hesitation.

I look forward to its release on the market.

My best to you.

Can you tell me which copy scheme you want to use: MT4->MT4, MT5->MT4, MT4->MT5 or MT5->MT5?

Why MT5 to MT4 doesn't work? 

Tried to copy GBPUSD (MT5) to GBPUSDm (MT4).

Any suggestion?

Hello, @Andreas Andrianto

At first, check, that you set rule for conversion in [Symbols] parameter like that:
GBPUSD=GBPUSDm

At second, check which is total conversion ratio between Sender and Receiver. If in too small, it also may be cause, that Receiver don't open positions after Sender
Did any of this help?

Hello, @lafjcr

Now you can do it only if run two terminals for one trading account and on each terminal add one instance of Real Trade Copy. 

Initially, I specifically removed the ability to run multiple copies of the RTC Receiver on the same terminal to protect against accidentally running multiple copies. In the next version, perhaps I will make changes that will allow multiple copies to be run in one terminal. But I would still like to exclude the accidental unwanted launch of several copies.

Can you write how many copies you planned to run so that I could make the most convenient solution? 

Hi @Yuriy thanks for your quick reply (I didn't see until today)

I don't have an exact number in my mind but I think you could add a validation to allow running multiple receiver copies only if the sender name is different so in that case you can keep your protection against accidentally running multiple copies.

Kind regards.