close at stop during strategy tester help please

New comment
 

hello all


i am getting close at stop type order why i am testing my EA any one can help to fix this 


close at stop

 
Ayman Tawil:

hello all

i am getting close at stop type order why i am testing my EA any one can help to fix this 


What is there to fix?

The tester closes any open trades at the end of the test period.

 
Keith Watford:

What is there to fix?

The tester closes any open trades at the end of the test period.

now i understand


thank you 

 
Keith Watford:

What is there to fix?

The tester closes any open trades at the end of the test period.

why i am getting big loss and close at stop

 
Ayman Tawil:

why i am getting big loss and close at stop

Because the trades made a loss.

Isn't that obvious???

 

You opened 0.5 lots at 1.11991 with a SL of 1.00000 — 1199 pips. What do you expect?

All your orders are at 0.5 lots. Control your risk.

Never risk more than a small percentage of your account, certainly less than 2% per trade, 6% total to the account.

Risk depends on your initial stop loss, lot size, and the value of the pair. It does not depend on margin and leverage. No SL means you have infinite risk.

  1. You place the stop where it needs to be — where the reason for the trade is no longer valid. E.g. trading a support bounce the stop goes below the support.
  2. AccountBalance * percent/100 = RISK = OrderLots * (|OrderOpenPrice - OrderStopLoss| * DeltaPerLot + CommissionPerLot) (Note OOP-OSL includes the spread, and DeltaPerLot is usually around $10/pip but it takes account of the exchange rates of the pair vs. your account currency.)
  3. Do NOT use TickValue by itself - DeltaPerLot and verify that MODE_TICKVALUE is returning a value in your deposit currency, as promised by the documentation, or whether it is returning a value in the instrument's base currency.
              MODE_TICKVALUE is not reliable on non-fx instruments with many brokers - MQL4 programming forum 2017.10.10
              Is there an universal solution for Tick value? - Currency Pairs - General - MQL5 programming forum 2018.02.11
              Lot value calculation off by a factor of 100 - MQL5 programming forum 2019.07.19
  4. You must normalize lots properly and check against min and max.
  5. You must also check FreeMargin to avoid stop out

Most pairs are worth about $10 per PIP. A $5 risk with a (very small) 5 PIP SL is $5/$10/5 or 0.1 Lots maximum.

New comment
Reason: