Maximum profit (MFE) and maximum loss (MAE) values are recorded for each open order during its lifetime. These parameters additionally characterize each closed order using the values of the maximum unrealized potential and maximum permitted risk. MFE/Profit and MAE/Profit distribution graphs display each order as a point with received profit/loss value plotted along the X-axis, while maximum displayed values of potential profit (MFE) and potential loss (MAE) are plotted along the Y-axis.
Place your cursor over parameters/graph captions to see the best and worst trading series. Find out more about MAE and MFE distributions in the article Mathematics in Trading: How to Estimate Trade Results.
The average slippage based on execution statistics on real accounts of various brokers is specified in pips. It depends on the difference between the provider's quotes from "RoboForex-Pro" and the subscriber's quotes, as well as on order execution delays. Lower values mean better quality of copying.
Welcome to this signal.
This signal follows mostly fundamental factors. Central Banks monitory policies , interest rate decisions ,inflation, GDP and employment situation.
That being said signal does not ignores the technical factors.
Signal has some rules/features. Following are few of them.
1) Signal will carry a maximum of three trades on any one specific pair.
2) 10 trades are the maximum number of open trades at any time.
3) Signal will carry trades over the weekend(if needed).
4) Signal trades only major pairs.
5) The allowable DD is 35%.
6) Signal will not make a deposit when there is DD.
7) Signal can make occasional withdrawals but the amount and the number of withdrawals are not fixed.
8) Minimum amount should be 500$. Recommended amount is 1000$.
USE OF LOT MULTIPLIER.
I strongly advice NOT to use any lot multiplier while following FX STAR PRO signal. I repeat again NEVER TO USE LOT MULTIPLIER EA while following this signal.
I will give a very simple example.
Lets just assume a subscriber subscribed to signal with 1000usd.
The subscriber wanted to get a 3x lot. The signal opens 0.01 lot trade. If the subscriber using 95% of equity ,as the ratio between provider and subscriber is 200:1000 (1:5). Subscriber on normal case will get 0.05 lot trade but with 3x lot multiplier now the total lots are 0.15 lots. Now assume again the signal goes under DD of 30%. The subscriber by using 3x lot multiplier will get devastating DD of 90% and eventually a MARGIN CALL.
SPECIAL USE OF LOT MULTIPLIER.
I will give another real example of a subscriber where i told that subscriber it will be fine to use the lot multiplier. The subscriber was using a broker that uses UNIT system over the LOTS system. His balance(equity) was 1500$ and was using 95% of the equity. 230:1425,simplifying the ratio give a bit higher than 6 times the balance from signal. In simple words, the subscriber should be getting 6 times the lot of provider. But the subscriber was getting a lower lots.
In such cases where the broker uses different parameters ,you can use lot multiplier ,but you have to keep the ratio.
"provider equity : subscriber equity "
Please contact me if i'm using a difficult method for you.