• Overview
  • Reviews
  • Comments (22)

ForexAurum Arbitrage

ForexAurum Arbitrage is a strategy based on moving average indicators combined with arbitrage. It uses the 3 major assets EURUSD, EURGBP and GBPUSD or their sub assets like EURUSDecn, EURGBPecn and GBPUSDecn. This EA tracks the best opportunities to open three positions at each time. The basic parameters are well optimized to get a good result but you can setup your own configuration (see some configurations below).

Y‌ou have to attach the EA in only one of the 3 Assets chart, by default it's tested on EURUSD 1 minute chart (you don't have to attach it at the all the charts). You can use it for all accounts types even the micro ones ($100 with minimum 1:200).


Risks and recommendation

Since the EA uses arbitrage, it is a Slippage sensitive strategy. You must be sure that your broker offers a low slippage for execution and also try to choose a good VPS with low network latency. We recommend trying it first on a demo account to recognize and understand the parameters first. Also, trade only the capital you are prepared to lose.


Parameters description

  • M‌AGICMA: The Magic Number of the opened 3 positions.
  • AssetPrefix: Change it only if your broker does not use the default asset names, and the asset are prefixed, then you can precise the prefix (ex: AssetPrefix=fx -> you will trade fxEURUSD, fxEURGBP and fxGBPUSD).
  • AssetSuffix: Change it only if your broker does not use the default asset names, and the asset are suffixed, then you can precise the suffix (ex: AssetSuffix=ecn -> you will trade EURUSDecn, EURGBPecn and GBPUSDecn).
  • Spread: for 5 digits broker you can set it from 0.0015 to 0.0001.
  • Lot : Lot size to open positions. If your Account is $1000 we recommend to set it to 0.1 lot, since the EA is Scalping.
  • Profit: this parameter is money profit not pips. If the three open positions profit is higher than this parameters we will close the 3 positions with this profit.
  • Loss: this parameter is money loss not pips if the three open positions loss is higher than this parameters we will close the 3 positions with this loss.
  • Slippage: select permitted deviation.
  • flashMode: activate it if you are a risky trader, the EA will increase the trading lots, profit and Loss while the balance increases.
  • amountStep: each time the balance will increase by this amount the factor will be increase by 1.

Assuming your configuration is (Lot = 0.1, Profit = 5, Loss = 100) and you want to use flashMode with 1000 as amount step (flashMode = true, amountStep = 1000).

The lot, Profit, and Loss will be multiplied by the factor F = Balance / amountStep until you reach the maximum allowed size of the trading volume according to the table:

Balance | Factor | Lots | Profit | Loss

  • 1000 | 1| 0.1 | 5| 100
  • 2000 | 2| 0.2 | 10| 200
  • 10000 | 10| 1 | 50| 1000


Recommended Configurations

Parameters for small ($1000) and micro ($100) account:

  • Spread = 0.0002 or 0.0005
  • Lot = 0.1
  • Profit = 5‌
  • Loss = 10‌0

‌Parameters for large ($10000) and small ($1000) account:

  • Spread = 0.0002 or 0.0005
  • Lot = 0.5
  • Profit = 20
  • Loss = 50‌0

‌‌Parameters for large ($10000):

  • Spread = 0.0002 or 0.0005
  • Lot = 1
  • Profit = 50
  • Loss = 1000
No reviews